How to Remote Start a Robot: Changes for R-50iA (Part 3)

In this video, we will go over what has changed in the setup steps for implementing the remote start functionality on the R-50iA controller as compared to the R-30iB Plus controller. Rather than covering all parts of the remote start setup process, this video focuses solely on the setup differences between controller generations.

We begin with a reminder of the other Tech Transfer Short videos available that provide step-by-step instructions for remote start setup on the R-30iB controller. From there, we shift our attention to the R-50iA specific updates that affect how remote operation is configured.

A primary focus of the video is understanding where familiar settings have moved and how their behavior impacts remote mode operation. We will walk step by step through the System Configuration and I/O Settings menus, calling out the settings that are necessary for enabling remote start on the R-50iA.

This video is designed for users already familiar with the R-30iB Plus setup process and focuses specifically on highlighting the critical differences in the newer controller generation; providing a clear and practical overview of the changes that matter most.

Recommended background knowledge and requirements include:

• Prior experience with remote start concepts and setup on R-30iB Plus systems
• Understanding of UOP and UI signal fundamentals
• Access to an R-50iA controller or ROBOGUIDE environment

By watching this video, we will go over how to:

• Navigate to the following settings on the R-50iA controller:
  • Remote/Local
  • Remote Start Device
  • Enable UI Signals
  • START for CONTINUE ONLY
  • CSTOPI for ABORT

If you are transitioning to the R-50iA controller or supporting systems that use multiple FANUC controller generations, this video provides a concise and practical overview to help ensure a smooth setup process and reliable remote operation.